Author Archives: Andrew Ziehl

About Andrew Ziehl

An avid outdoorsman.

Bagging the End of the AT

Just before the 4th, Rob, Sweeney and I were up with friends rafting near Baxter State Park. Though the camping weather was overly moist, the rafting was a blast. That night Rob and I set our sights on peak bagging Katahdin.

We were heading out around 8 when our friend Ben showed up and we all drove off into Baxter. The hike began under cloudy skies into dense fog up from Abol campground. We quickly rose above treeline where the trail followed a rock slide and led us up one of the steepest continual ascent we’ve encountered since Great Gulf.

Poor visibility at the summit

Ben and I get the age old shot…even through we didn’t thru-hike

We summitted the nearly 4000 vertical gain in two hours flat. On the way up we’d decided to loop the hike by descending via the AT to expedite our trip.

Rob above the Knife edge

Heading down the AT was definitely the right choice as we were awarded great views and stopped briefly to chat with an early season thru-hiker. I pulled my phone out to snap photos only a few times as we made our way down.

We made the 9 mile loop in 4.5 hours but were still 2.2 miles from our car, which put us back at the rafting lodge a little later than we’d anticipated. Rob jogged and we speed walked to the car, very satisfied to have finally hiked Katahdin.

Go Outdoors, Whatever the Weather May Bring

Catherine: Back in early May, despite the weather reports, Andrew and I decided that we would go through with our plan to bike and camp the Cape Cod Rail Trail; a 26-mile route that goes from Dennis to Wellfleet. The weather didn’t lie, and it rained a lot, although we had pretty good luck with timing. We were able to set up our tent site at Nickerson State Park right before it downpoured. But then it basically rained the entire rest of our trip – stopping, of course, as soon as we reached the car Sunday morning.

Our campsite arrival

After setting up our site

Reaching Coast Guard beach

Andrew’s fire starting skills were tested in the rain, and he passed.

Andrew: Biking in and out of Nickerson was the hilliest part, but after we diverged from the rail trail and headed for Coast Guard beach was when it really turned into an adventure. The winds picked up and threatened to blow us over.

We met up with some of Catherine’s friends in the evening who were kind enough to provide us with comfort foods: delicious snacks and beers.

All in all a great weekend, despite the rain.

Glitch in the Matrix

When one of your adventuring vehicles has problems, you have several options. In the interest of saving money for an upcoming Seattle/Portland trip, Catherine and I opted for the do-it-yourself discbrake/rotor repair.

We bought the parts, and with the right Autozone tool rentals, got the job done without too much trouble. To give a quick run down:

Catherine loosens the tires.

Jack the car up. Chock the wheels. Put it in neutral. Read the manual for this one since I wasn’t familiar with Catherine’s car.

Me unbolting the caliper after removing a tire. Remove the worn pads. If the rotor shows signs of improper wear (It shouldn’t), replace it.

Compress the brake caliper. For rear brake calipers that require a twist to compress, rent the tool from Autozone. You did rent it right?

Compressing the front caliper with a C clamp

Unusual wear from only the driver’s side rear pads, which tore up the rotor.

To replace the rotor, unbolt the caliper bracket, and then use a bolt from the caliper screwed into the rotor to pop it off the axle. Then seat the new (cleaned) rotor, and re-assemble. Before you replace rotors, make sure to clean the new ones.

Secure new pads into the bracket, and apply sound dampener (the orange glue). Re-attach the caliper, and then put the wheel back on, tightening the bolts evenly to 100 foot lbs.

The first try it took us a second trip to Autozone to acquire the brake tool, and we ran out of time. Our second attempt, while doing the rear wheels, went incredibly smoothly, especially considering there is no Haynes manual for her car. Working with someone else on a job like this helps as well.

Consolation Prize

I met up with Sweeney, Rob, and Kelly after their eventful day in the bowl, with plans to ski the next day. Understandably, only Rob was considering a second tour.

We got an early start and headed to the West side to met up with Dalton & friends. Three of us ended up skinning and hiking into some terrain the was new to me. We thought we could skin all the way, but that wasn’t quite true.

Some spring features opening up.

The second crossing, with some views.

The summit from a new angle…

When Dalton and I got to our destination we transitioned for a quick traverse. I clicked in, weighted my downhill ski, and it immediately went careening down the hill. Dalton took off after it, when I couldn’t catch it. Moments later I peered over a roll-over and saw it laying dejectedly among some rocks, damaged but alright. The culprit was a loose heel piece. Somehow the screws on my swap plate loosened themselves, adding (yet another) pre-release the the weekend.

I thought it was game over until I eventually found some kind French Canadians with tools (that I usually carry) and met back up with Dalton and Nick to wrap up afternoon with some great spring corn.

Original run #1, that became run #2

We skinned out and around, over and down into a sweet long gully of pristine corn. The following shots are credit to Dalton, posted on the Worth skis FB page.

Making up for the morning…

The prize, as shot from the runout by Dalton

The last run, and the beer afterwards, saved the day, especially considering no one, and no gear was seriously injured.